5 november 2013
Empa scientists have developed a new technique for manufacturing high-efficiency, flexible, thin film solar cells from CIGS (copper indium gallium di-selenide) semiconductors. This has enabled them to achieve an efficiency of 20.4% for the conversion of sunlight into electrical energy. As the solar cells are deposited onto plastic foils, they could be produced on an industrial scale using cost-effective roll-to-roll manufacturing.
For many years scientists and engineers have been trying to provide low-cost solar energy by developing a cheap solar cell that is both highly efficient and at the same time simple to build, enabling it to be mass produced. Now, the team led by Empa researcher Ayodhya N. Tiwari has made a major leap forward: the researchers are presenting a new manufacturing technique for CIGS solar cells, in which tiny quantities of sodium and potassium are incorporated into the CIGS layer. The special treatment alters the chemical composition of the complex sandwich structure – thereby altering its electronic properties, as confirmed by various methods including detailed electron microscope investigations. Details of the new method have now been published as an "Advance Online Publication" in the renowned journal "Nature Materials".
With this technique, the Empa team has again been able to significantly increase the energy conversion efficiency from sunlight into electricity using CIGS thin film solar cells on flexible plastic foils – to a new record level of 20.4%, representing a marked improvement over the previous record of 18.7% established by the same team in May 2011. This finally enables CIGS cells to compete with the best polycrystalline silicon cells. Until recently, the Empa CIGS cells were the most efficient in the world; at the end of October, though, a German research team at the Zentrum für Sonnenenergie- und Wasserstoff-Forschung (ZSW) in Stuttgart presented CIGS cells with an efficiency of 20.8%, although they use far higher processing temperatures and (rigid) glass as the substrate. The slightly improved record shows that CIGS thin film technologies are a "hot" topic – and that Empa is right at the cutting edge.
Potassium-induced surface modification of Cu(In,Ga)Se2 thin films for high-efficiency solar cells, A. Chirila, P. Reinhard, F. Pianezzi, P. Bloesch, A.R. Uhl, C. Fella, L. Kranz, D. Keller, C. Gretener, H. Hagendorfer, D. Jaeger, R. Erni, S. Nishiwaki, S. Buecheler, A.N. Tiwari, Nature Materials, 2013, doi:10.1038/nmat3789 Empa media release (January 2013)